LUBRICATION SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT ENGINE OIL LEVEL |
Warm up and stop the engine, then wait for 5 minutes.
Check that the engine oil level is between the low level and full level marks on the engine oil level dipstick.
If the level is low, check for engine oil leaks and add engine oil to the full level mark.
| 2. INSPECT ENGINE OIL QUALITY |
Check the engine oil for deterioration, water intrusion, discoloration or thinning.
If the quality is visibly poor, replace the engine oil and oil filter element.
| 3. INSPECT OIL PRESSURE |
Remove the oil pressure sender gauge assembly (Click here).
![]() |
Install an oil pressure gauge with the adapter.
Warm up the engine.
Measure the oil pressure.
| Engine Condition | Oil Pressure |
| Idling | 50 kPa (0.5 kgf/cm2 7.3 psi) or higher |
| 4000 rpm | 260 kPa (2.7 kgf/cm2, 38 psi) or higher |
Remove the oil pressure gauge with the adapter.
Install the oil pressure sender gauge assembly (Click here).