DTC C1441 Performance Decline of Brake Function |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
| C1441 | Performance Decline of Brake Function | When the brake pedal load sensing switch and master cylinder pressure sensor are functioning normally and the brake pedal load sensing switch is judged as on, the pressure signal from the master cylinder pressure sensor does not indicate an increase. |
|
| 1.CHECK ACCELERATOR PEDAL AND BRAKE PEDAL OPERATION |
Interview the customer to check if the pedals were depressed simultaneously while driving or braking.
|
| ||||
| OK | |
| 2.CHECK DTC AND FREEZE FRAME DATA |
Check and record DTCs and Freeze Frame Data (Click here for Check DTCs and Click here for Freeze Frame Data).
| NEXT | |
| 3.CLEAR DTC |
Clear the DTCs and Freeze Frame Data (Click here for Clear DTCs and Click here for Freeze Frame Data).
| NEXT | |
| 4.CHECK BRAKE PEDAL OPERATION |
Based on the customer problem analysis, confirm the brake pedal condition at the time the brake pedal was operated.
| Result | Proceed to |
| The brake pedal is hard to depress. | A |
| The brake pedal is extremely easy to depress. | B |
| Neither of the above conditions. (Problem symptom does not occur.) | C |
|
| ||||
|
| ||||
| A | |
| 5.CHECK BRAKE BOOSTER ASSEMBLY |
Check the brake booster assembly (Click here for LHD or Click here for RHD).
| Result | Proceed to |
| The brake booster assembly is abnormal. | A |
| The brake booster assembly is normal. | B |
|
| ||||
| A | ||
| ||
| 6.CHECK BRAKE FLUID LEVEL |
Check that the brake fluid level is sufficient.
| Result | Proceed to |
| Brake fluid level is not sufficient. | A |
| Brake fluid level is sufficient. | B |
|
| ||||
| A | ||
| ||
| 7.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Perform a road test.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC C1441 is not output. | A |
| DTCs C1441 and other DTC are output. | B |
| Only DTC C1441 is output. | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 8.CHECK BRAKE PEDAL SUPPORT ASSEMBLY |
Check that the matchmarks on the adjustment part of the brake pedal load sensing switch are aligned with the matchmarks on the brackets, nuts, adjusting screw, etc.

| *A | for LHD | *B | for RHD |
| *1 | Brake Pedal Load Sensing Switch | - | - |
| *a | Matchmark | - | - |
| Result | Proceed to |
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
|
| ||||
|
| ||||
| A | ||
| ||