Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

DTC    C1625    Open or Short in Steering Angle Sensor +B

for Preparation Click here


DESCRIPTION

This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem.

DTC No.
DTC Detection Condition
Trouble Area
C1625
Open or short in steering sensor power source
  1. Harness or connector
  2. Steering sensor

WIRING DIAGRAM


E288975E16


INSPECTION PROCEDURE

NOTICE:
  1. If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).
  3. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE)
  1. Disconnect the I29 steering sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I29-1 (ESS) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I29-4 (IG) - I29-1 (ESS)
    Ignition switch ON
    11 to 14 V
    I29-5 (BAT) - I29-1 (ESS)
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STEERING SENSOR (Click here)