WIRELESS CHARGING SYSTEM > Status Signal Circuit |

| 1.INSPECT UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D194-7 (DIS) - Body ground | For 5 seconds after turning engine switch from off to on (ACC)*1 | 4.5 to 6.0 V |
| Device being charged | Below 1 V | |
| Charging suspended due to smart entry and start system status*2 | 4.5 to 6.0 V |
| *a | Component with harness connected (Upper Console Panel Sub-assembly) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (UPPER CONSOLE PANEL SUB-ASSEMBLY - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)) |
Disconnect the I194 upper console panel sub-assembly connector.
Disconnect the O1 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I194-7 (DIS) - O1-7 (ASEL) | Always | Below 1 Ω |
| I194-7 (DIS) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||