Wireless Charging System
Symptom
| Suspected Area
| See page
|
Even when the wireless charging system is turned on, the indicator light (green) does not illuminate
| Inspect wire harness and connector (Mobile wireless charger cradle assembly connector terminals: I194-6 (B+), I194-5 (ACC) and I194-1 (PGND))
|
Click here
|
Mobile wireless charger cradle assembly
|
Click here
|
When the wireless charging system is turned on, the indicator (green) illuminates, but the indicator (amber) does not illuminate when a rechargeable device is placed on the charging area (wireless charging does not start)
| Check that the device being used is a Qi-compatible rechargeable device
| -
|
Remove any cases and accessories
| -
|
Check that there is no gap between the rechargeable device and the charging area
| -
|
Check that there is no foreign matter between the rechargeable device and the charging area
| -
|
Check that the rechargeable device is not fully charged
| -
|
Check that the rechargeable device is centered on the charging area
| -
|
Check that the rechargeable device is placed on the charging area with its charging surface facing down
| -
|
Check that the vehicle is not in an environment where it may be affected by strong radio waves or electrical noise
| -
|
Check if more than 1 rechargeable device is placed on the charging area
| -
|
Check that a charging cable is not connected to the rechargeable device
| -
|
Check that temperature of the rechargeable device is not excessively high or low
| -
|
Check if wireless charging of the rechargeable device is possible using another Qi-compatible wireless charging system
| -
|
Check if wireless charging is possible using another Qi-compatible rechargeable device
| -
|
Status signal circuit
|
Click here
|
Mobile wireless charger cradle assembly
|
Click here
|
When the wireless charging system is turned on, the indicator (green) illuminates and when a rechargeable device is placed on the charging area, the indicator (amber) illuminates, but the indicator (green) illuminates again before wireless charging is completed (wireless charging does not complete)
| Check if the rechargeable device has not been moved out of the charging area
| -
|
Check that temperature of the rechargeable device is not excessively high or low
| -
|
Check that the vehicle is not in an environment where it may be affected by strong radio waves or electrical noise
| -
|
Status signal circuit
|
Click here
|
Mobile wireless charger cradle assembly
|
Click here
|
Even when the light control switch is turned to the tail or head position, the mobile wireless charger switch does not illuminate or the indicator light does not dim
| Inspect wire harness and connector (Mobile wireless charger cradle assembly connector terminal: I194-10 (TAIL))
|
Click here
|
Mobile wireless charger cradle assembly
|
Click here
|
The indicator light (amber) blinks (pattern 1)*
| Status signal circuit
|
Click here
|
Mobile wireless charger cradle assembly
|
Click here
|
The indicator light (amber) blinks (pattern 2)*
| Check if the charging frequency is being changed
|
Click here
|
Mobile wireless charger cradle assembly
|
Click here
|
The indicator light (amber) blinks (pattern 3)*
| Check that the device being used is a Qi-compatible rechargeable device
| -
|
Remove any cases and accessories
| -
|
Check that there is no gap between the rechargeable device and the charging area
| -
|
Check that there is no foreign matter between the rechargeable device and the charging area
| -
|
Check that the rechargeable device is centered on the charging area
| -
|
Check that the rechargeable device is in the same position as when charging was started
| -
|
Mobile wireless charger cradle assembly
|
Click here
|
The indicator light (amber) blinks (pattern 4)*
| Check that temperature of the mobile wireless charger cradle assembly is not excessively high
| -
|
Mobile wireless charger cradle assembly
|
Click here
|