Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1A45    Vehicle Speed Sensor

for Preparation Click here


DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.

DTC No.
DTC Detection Condition
Trouble Area
C1A45
A fail flag is transmitted from the skid control ECU.
  1. Vehicle stability control system
  2. Blind spot monitor sensor RH
  3. Blind spot monitor sensor LH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

1.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
  1. Check for DTCs of the vehicle stability control system (Click here).

    OK:
    Vehicle stability control system DTCs are not output.



NG
GO TO VEHICLE STABILITY CONTROL SYSTEM (Click here)
OK


2.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    Result:
    Result
    Proceed to
    No DTCs are output.
    A
    DTC is output from the blind spot monitor sensor RH (Master).
    B
    DTC is output from the blind spot monitor sensor LH (Slave).
    C



B
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)