POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Front Door Windows) > Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated) |
| 1.PERFORM INITIALIZATION (APPLICABLE LOCATION) |
Initialize the power window regulator motor assembly (applicable location) (Click here).
| NEXT | |
| 2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION (APPLICABLE LOCATION)) |
Check that each front power window moves when the auto up and down function of the power window regulator master switch assembly or power window regulator switch assembly are operated (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION) |
Remove the power window regulator motor assembly and door window regulator sub-assembly.
Install the window glass to the door glass run.
Check if the power window regulator motor assembly and door window regulator sub-assembly operate smoothly.
Check that the window glass slides smoothly when sliding it down by hand.
|
| ||||
| OK | ||
| ||