DTC P001013 A Camshaft Position Actuator Bank 1 Circuit Open |

| DTC No. | DTC Detection Condition | Trouble Area |
| P001013 | Open or short in cam timing oil control solenoid assembly circuit (1 trip detection logic). |
|
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ OUTPUT DTC (DTC P001013) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTC after recording the freeze frame data and DTC.
Turn the engine switch off and wait for at least 30 seconds.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P001013 is output | A |
| DTCs are not output | B |
|
| ||||
| A | |
| 2.INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY |
Inspect the cam timing oil control solenoid assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAM TIMING OIL CONTROL SOLENOID ASSEMBLY - ECM) |
Disconnect the cam timing oil control solenoid assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E98-2 - E96-9 (OC1+) | Always | Below 1 Ω |
| E98-1 - E96-8 (OC1-) | Always | Below 1 Ω |
| E98-2 or E96-9 (OC1+) - Body ground and other terminals | Always | 10 kΩ or higher |
| E98-1 or E96-8 (OC1-) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||