DTC P008800 Fuel Rail / System Pressure - Too High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P008800 | Although the ECM is not requesting the fuel pump (for high pressure side) to open the spill control valve, fuel pressure increases 3 MPa (30.6 kgf/cm2, 435 psi) from target pressure for about 10 seconds (1 trip detection logic). |
|
| Required Sensors/Components | Fuel pressure sensor |
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P008800) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P008800 is output | A |
| DTC P008800 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK FUEL PRESSURE SENSOR |
Connect the GTS to the DLC3.
Start the engine and turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Fuel Pressure (High).
Check that the fuel pressure fluctuates when the engine is raced.
|
| ||||
| OK | |
| 3.REPLACE FUEL PUMP (FOR HIGH PRESSURE SIDE) |
Replace the fuel pump (for high pressure side) (Click here).
| NEXT | |
| 4.CHECK IF DTC OUTPUT RECURS (SEE IF DTC P008800 IS OUTPUT AGAIN) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG).
Turn the GTS on.
Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P008800 is output | A |
| DTCs are not output | B |
|
| ||||
| A | ||
| ||