DTC P011015 Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P011015 | The intake air temperature sensor output voltage is higher than 4.91 V for 0.5 seconds or more (1 trip detection logic). |
|
| DTC No. | Intake Air Temperature | Malfunction |
| P011015 | -40°C (-40°F) |
|
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ VALUE USING GTS (CHECK FOR OPEN IN WIRE HARNESS) |
Disconnect the mass air flow meter sub-assembly connector.

| *1 | Mass Air Flow Meter Sub-assembly | *2 | ECM |
| *a | Front view of wire harness connector (to Mass Air Flow Meter Sub-assembly) | - | - |
Connect terminals 4 (THA) and 2 (E2G) of the mass air flow meter sub-assembly connector on the wire harness side.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Intake Air Temperature.
Read the value displayed on the GTS.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (MASS AIR FLOW METER SUB-ASSEMBLY - ECM) |
Disconnect the mass air flow meter sub-assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E105-4 (THA) - E96-94 (THA) | Always | Below 1 Ω |
| E105-2 (E2G) - E96-91 (E2G) | Always | Below 1 Ω |
| E105-4 (THA) or E96-94 (THA) - Other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||