DTC P019511 Engine Oil Temperature Sensor Circuit Short to Ground |
| DTC No. | DTC Detection Condition | Trouble Area |
| P019511 | The engine oil temperature sensor output voltage is less than 0.12 V for 5 seconds or more (1 trip detection logic). |
|
| DTC No. | Engine Oil Temperature Sensor | Malfunction |
| P019511 | 164°C (327°F) or higher | Short to ground in THEO circuit |
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING GTS (CHECK FOR SHORT IN WIRE HARNESS) |
![]() |
Disconnect the engine oil temperature sensor connector.
| *1 | Engine Oil Temperature Sensor |
| *2 | ECM |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Engine Oil Temperature Sensor.
Read the value displayed on the GTS.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ENGINE OIL TEMPERATURE SENSOR - ECM) |
Disconnect the engine oil temperature sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E102-1 (THEO) or E96-97 (THEO) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||