DTC P210900 Throttle/Pedal Position Sensor "A" Minimum Stop Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P210900 | The Throttle Air Flow F/B Value* approaches its limit even though the actual intake air amount during idling is within the normal range (up to 1.5 times the normal amount) (5 trip detection logic).
| Throttle body with motor assembly |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P210900) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P210900 is output | A |
| DTC P210900 and other DTCs are output | B |
|
| ||||
| A | |
| 2.READ FREEZE FRAME DATA |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Using the GTS, check "Throttle Air Flow F/B Value" in the freeze frame data (Click here).
| NEXT | |
| 3.REMOVE FOREIGN MATTER (CLEAN THROTTLE BODY WITH MOTOR ASSEMBLY) |
Clean off any deposits from the inside of the throttle body with motor assembly.

| *1 | Throttle Body with Motor Assembly | *2 | Bore |
| *3 | Valve | - | - |
| *a | Reference | *b | Throttle Body with Motor Assembly Cross-section Diagram |
| *c | When valve fully opened | *d | Do not directly apply cleaner |
| *e | Deposits | - | - |
Push open the throttle valve and wipe off any carbon from the valve and bore using a cloth soaked in non-residue solvent.
| NEXT | |
| 4.READ VALUE USING GTS (THROTTLE AIR FLOW F/B VALUE) |
Perform "Inspection After Repair" after cleaning the throttle body with motor assembly (Click here).
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Throttle Air Flow F/B Value.
Read the value.
|
| ||||
| OK | ||
| ||