DTC P04019C Exhaust Gas Recirculation "A" Low / Insufficient Flow |
| DTC No. | DTC Detection Condition | Trouble Area |
| P04019C | Change in intake manifold pressure is small when the EGR valve opened and closed during fuel cut operation (2 trip detection logic). |
|
| Required Sensors/Components (Main) | EGR valve assembly Manifold absolute pressure sensor |
| Required Sensors/Components (Related) | Engine coolant temperature sensor Vehicle speed sensor |
| Frequency of Operation | Once per driving cycle |

| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| Data List Item | Change in Data List when Number of Steps is Increased Using Control the EGR Step Position Active Test |
| Engine Speed | Idle becomes rough |
| Intake Manifold Absolute Pressure | Pressure rises |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P04019C) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P04019C is output | A |
| DTC P04019C and other DTCs are output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING GTS (CONTROL THE EGR STEP POSITION) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or higher.
Enter the following menus: Powertrain / Engine / Active Test / Control the EGR Step Position / Data List / All Data / Engine Speed and Intake Manifold Absolute Pressure.
Check the engine idling condition and Intake Manifold Absolute Pressure values in the Data List while performing the Active Test.
| - | EGR Step Position (Active Test) | |
| 0 Steps | 0 to 30 Steps | |
| Idling condition | Steady idling | Idling changes from steady to rough idling or engine stalls |
| Intake Manifold Absolute Pressure (Data List) | Intake Manifold Absolute Pressure value is 20 to 40 kPa(abs) (150 to 300 mmHg(abs)) (EGR valve is fully closed) | Intake Manifold Absolute Pressure value is at least +10 kPa (75 mmHg) higher than when EGR valve is fully closed |
|
| ||||
| OK | |
| 3.INSPECT EGR VALVE ASSEMBLY |
Remove the EGR valve assembly (Click here).
Check for contamination between the EGR valve and housing.
|
| ||||
|
| ||||
| 4.REPLACE EGR VALVE ASSEMBLY |
Replace the EGR valve assembly (Click here).
| NEXT | |
| 5.CHECK FOR DEPOSIT (EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY AND INTAKE PORT TO EGR VALVE ASSEMBLY) |

Check for exhaust gas leaks at each connection point.
Check for cracks, damage, and clogs in the pipes between the exhaust manifold converter sub-assembly, the intake manifold and the EGR valve assembly.
This check may require the removal of components.
Check if there is a built-up of deposits in the EGR valve of pipes.
|
| ||||
| OK | |
| 6.INSPECT EGR COOLER ASSEMBLY |
Check for blockage of the EGR cooler assembly.
|
| ||||
| OK | |
| 7.READ VALUE USING GTS (INTAKE MANIFOLD ABSOLUTE PRESSURE) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Intake Manifold Absolute Pressure.
Read the Intake Manifold Absolute Pressure value.
| Condition | GTS Display |
| Engine switch on (IG) | 68 to 110 kPa(abs) [510 to 825 mmHg(abs)] |
|
| ||||
|
| ||||
| 8.CHECK INTAKE SYSTEM |
Check the intake system for vacuum leaks (Click here).
|
| ||||
| OK | |
| 9.REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR |
Replace the manifold absolute pressure sensor (Click here).
| NEXT | |
| 10.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG).
Turn the GTS on.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes / Pending.
Read the pending DTCs.
Enter the following menus: Powertrain / Engine / Utility / All Readiness.
Input the DTC: P04019C.
Check the DTC judgment result.
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| NEXT | ||
| ||