FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK |
Check fuel pump operation.
Connect the GTS to the DLC3.
Turn the engine switch to on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Activate the Circuit Relay.
Check for pressure in the fuel tube sub-assembly from the fuel line. Check that sounds of fuel flowing from the fuel tank assembly can be heard. If no sounds can be heard, check the integration relay, fuel pump, ECM and wiring connectors.
Inspect for fuel leaks.
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.
Turn the engine switch off.
Disconnect the GTS from the DLC3.
| 2. CHECK FUEL PRESSURE |
Discharge fuel system pressure.
Measure the battery voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Positive (+) terminal - Negative (-) terminal | Engine switch off | 11 to 14 V |
Disconnect the cable from the negative (-) battery terminal.
Remove the fuel pump protector .
Disconnect the fuel tube sub-assembly (for Direct Injection).
![]() |
Disconnect the fuel tube sub-assembly from the No. 1 fuel pipe (Click here).
Disconnect the fuel tube sub-assembly (for Port Injection).
![]() |
Disconnect the fuel tube sub-assembly from the fuel delivery pipe (Click here).
![]() |
Install SST (EFI fuel pressure gauge) as shown in the illustration.
| *1 | Fuel Tube Sub-assembly (Vehicle Side) |
| *a | SST (Hose Band) |
| *b | SST (T-joint) |
| *c | SST (Gauge) |
| *d | SST (Hose Joint) |
| *e | SST (Hose) |
| *f | SST (Fuel Tube Connector) |
| *g | Fuel Pipe (Vehicle Side) |
Wipe up any spilled fuel.
Connect the cable to the negative (-) battery terminal.
Connect the GTS to the DLC3.
Turn the engine switch to on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Active Test / Activate the Circuit Relay.
Measure the fuel pressure.
Disconnect the GTS from the DLC3.
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes.
After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST to prevent fuel from spraying.
Connect the fuel tube sub-assembly (for Port Injection).
Connect the fuel tube sub-assembly to the fuel delivery pipe (Click here).
Connect the fuel tube sub-assembly (for Direct Injection).
Connect the fuel tube sub-assembly to the No. 1 fuel pipe (Click here).
Install the fuel pump protector .
Inspect for fuel leaks.
| 3. CHECK FUEL PRESSURE (for High Pressure) |
Connect the GTS to the DLC3.
Turn the engine switch to on (IG).
Turn the GTS on.
Start and warm up the engine.
Enter the following menus: Powertrain / Engine / Data List / Fuel Pressure (High).
Check the high pressure side fuel pressure.
Stop the engine.