Home › Engine / Hybrid System ยท 6AR-FSE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)


2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A136021
  1. Disconnect the fuel sender gauge assembly connector.



    A136022E01
  1. Push the claw (A) of the fuel sender gauge assembly, and then pull up the fuel sender gauge assembly to remove it.

    NOTICE:
    1. Do not touch the resistance plate or contacts of the fuel sender gauge assembly.
    2. Be careful not to bend the arm of the fuel sender gauge assembly.



3. REMOVE LOWER FUEL TANK CASE SUB-ASSEMBLY


    A136231
  1. Disconnect the fuel pump harness connector.

  1. Disconnect the fuel pump harness from the fuel suction plate sub-assembly.



    A136234E04
  1. Using needle nose pliers, remove the E-ring.
    Text in Illustration 
    *1
    E-ring



    A338473E01
  1. Disengage the 4 claws of the No. 1 fuel suction support and remove the lower fuel tank case sub- assembly from the fuel suction plate sub-assembly with the fuel filter.
    Text in Illustration 
    *a
    Tube

    NOTICE:
    Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube (Click here).

  1. Remove the spring from the shaft of the fuel suction plate sub-assembly.



4. REMOVE NO. 1 FUEL SUCTION SUPPORT


    A338474E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter.
    Text in Illustration 
    *a
    Protective Tape



5. REMOVE FUEL PUMP


    A338475E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
    Text in Illustration 
    *a
    Fuel Filter
    *b
    Suction Filter
    *c
    Protective Tape

    NOTICE:
    1. Do not damage the fuel filter.
    1. Do not remove the suction filter.
    1. Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.



    A283925
  1. Disconnect the fuel pump harness connector to remove the fuel pump harness from the fuel pump.



    A292649E03
  1. Remove the O-ring and fuel pump spacer from the fuel pump.
    Text in Illustration 
    *1
    O-ring
    *2
    Fuel Pump Spacer
    *a
    5.0 mm (0.197 in.)

    NOTICE:
    Be careful not to damage the sealing surface.

    HINT:
    If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.



6. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A136235E01
  1. Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly from the fuel filter.
    Text in Illustration 
    *a
    Protective Tape

    NOTICE:
    Pull out the fuel pressure regulator assembly carefully because the O-rings are firmly installed between the fuel pressure regulator assembly and fuel filter.



    A148186E13
  1. Remove the 2 O-rings from the fuel pressure regulator assembly.
    Text in Illustration 
    *1
    O-ring