FUEL PUMP (for High Pressure) > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. PRECAUTION |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY |
| 5. REMOVE COOL AIR INTAKE DUCT SEAL |
![]() |
Remove the 9 clips and cool air intake duct seal.
| 6. REMOVE INLET AIR CLEANER ASSEMBLY |
![]() |
Remove the 2 bolts and inlet air cleaner assembly.
| 7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.
| 8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Disconnect the wire harness clamp.
Remove the 2 bolts and air cleaner case sub-assembly.
| 9. REMOVE FUEL PUMP PROTECTOR |
![]() |
Remove the 2 bolts and fuel pump protector from the cylinder head cover sub-assembly.
| 10. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
Disconnect the fuel tube sub-assembly from the No. 1 fuel pipe.
![]() |
Pull off the fuel tube connector cover.
| *a | Fuel Tube Connector Cover |
![]() | Pull off |
![]() |
Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.
| *a | Retainer |
| *b | Fuel Tube Connector |
| *c | Nylon Tube |
| *d | O-ring |
| *e | Fuel Pipe |
![]() | Pinch |
![]() | Pull |
If the fuel tube connector and fuel pipe are stuck, push and pull the fuel tube connector to release it. Pull the fuel tube connector off of the fuel pipe carefully.
Check that there is no foreign matter on the sealing surfaces of the disconnected fuel lines. Clean them if necessary.
Cover the disconnected fuel pipe and fuel tube connector with plastic bags to prevent damage and contamination.
| 11. REMOVE NO. 1 FUEL PIPE |
![]() |
Remove the No. 1 fuel pipe and gasket from the fuel pump with seal sub-assembly.
| 12. REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY |
![]() |
Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
![]() |
Loosen the 2 bolts of the fuel pump with seal sub- assembly.
Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe sub-assembly and fuel pump with seal sub- assembly.
| 13. REMOVE FUEL PUMP WITH SEAL SUB-ASSEMBLY |
![]() |
Disconnect the fuel pump with seal sub-assembly connector.
Remove the 2 bolts and fuel pump with seal sub- assembly from the cylinder head cover sub- assembly.
![]() |
Remove the fuel pump lifter guide, fuel pump lifter assembly and fuel pump insulator from the fuel pump with seal sub-assembly.
| *1 | Fuel Pump with Seal Sub-assembly |
| *2 | Fuel Pump Insulator |
| *3 | Fuel Pump Lifter Assembly |
| *4 | Fuel Pump Lifter Guide |
![]() |
Remove the O-ring from the fuel pump sub- assembly.
![]() |
Remove the fuel pump spacer gasket from the cylinder head cover sub-assembly.
| *1 | Fuel Pump Spacer Gasket |
| *2 | O-ring |
Remove the 2 O-rings from the No. 4 camshaft bearing cap.