Home › Power Source / Network ยท 6AR-FSE BATTERY / CHARGING › CHARGING SYSTEM

CHARGING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.


      The following 5 items are important points for problem analysis: 
      What
      Vehicle model, system name
      When
      Date, time, occurrence frequency
      Where
      Road conditions
      Under what conditions?
      Running conditions, driving conditions, weather conditions
      How did it happen?
      Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Check if CAN communication DTCs are output (Click here).

    2. Result 
      Result
      Proceed to
      CAN communication DTCs are not output.
      A
      CAN communication DTCs are output.
      B


    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC*

      HINT:
      Refer to DTC Check / Clear (Click here).

      Result 
      Result
      Proceed to
      DTCs are not output.
      A
      DTCs are output.
      B


    B.
    GO TO DTC CHART (Click here )
    A


    6.REFER TO PROBLEM SYMPTOMS TABLE

      HINT:
      Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Malfunctioning parts are not confirmed.
      A
      Malfunctioning parts are confirmed.
      B


    B.
    GO TO STEP 12
    A


    7.OVERALL ANALYSIS AND TROUBLESHOOTING*

      HINT:
      Refer to Data List / Active Test (Click here).

      Result 
      Result
      Proceed to
      Malfunctioning parts are not confirmed.
      A
      Malfunctioning parts are confirmed.
      B


    B.
    GO TO STEP 12
    A


    8.CHECK ECM CIRCUIT

      HINT:
      Refer to Terminals of ECM (Click here).



    NG.
    GO TO STEP 12
    OK


    9.CHECK FOR INTERMITTENT PROBLEMS

      HINT:
      Refer to Symptom Simulation (Click here).


    NEXT


    10.CONDUCT PARTS INSPECTION

      NEXT


      11.IDENTIFY PROBLEM

        NEXT


        12.ADJUST AND/OR REPAIR

          NEXT


          13.CONDUCT CONFIRMATION TEST

            NEXT

            END