Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › MASS AIR FLOW METER

MASS AIR FLOW METER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

HINT:
Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly (Click here).

  1. Read the value using the GTS (Mass Air Flow Sensor).

    NOTICE:
    Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).


    1. Connect the GTS to the DLC3.

    2. Start the engine.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.

    5. Wait for 30 seconds, and read the value on the GTS.

      Standard Condition:
      GTS Display
      Condition
      Specified Condition
      Mass Air Flow Sensor
      Idling
      (After the engine warms up)
      1.0 to 4.0 gm/sec
      2000 rpm
      (After the engine warms up)
      4.1 to 8.1 gm/sec
      3000 rpm
      (After the engine warms up)
      6.2 to 11.2 gm/sec

      If the result is not as specified, replace the mass air flow meter sub-assembly.
      If the result is within the specified range, inspect the mass air flow meter sub-assembly (Click here).



2. PERFORM INITIALIZATION
  1. Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly (Click here).