Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319013 ENGINE COOLANT TEMPERATURE SENSOR A

2AR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17705 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 89422 4.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A405038

Disconnect the engine coolant temperature sensor connector.


b.
A405039N01
1.469,1.01 1.833,1.01 1.833,1.01 1.833,0.615 true 1.146,0.927 1.458,1.115 0.313,0.188 10 true SST

Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.

SST
09817-33191  

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.



c.

Remove the gasket from the engine coolant temperature sensor.