Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319015 AIR FUEL RATIO SENSOR A

2AR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 2.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17167 3.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

Hide 89467B 4.REMOVE AIR FUEL RATIO SENSOR

CAUTION:
A344783

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A405043

Disengage the wire harness clamp.


b.

Disconnect the air fuel ratio sensor connector.


c.
A405044N01
1.552,1.865 1.552,1.635 true 1.438,1.875 1.75,2.063 0.313,0.188 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly (TWC: Front Catalyst).

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.