55708
1.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
53607A
2.REMOVE FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY
3. OPERATION CHECK
Slide the clip and disconnect the air tube from the vacuum pump assembly.
| *a | Vacuum Gauge |
| *b | Plug |
Connect the hose of the vacuum gauge to the vacuum pump assembly.
Start the engine and warm it up for more than 2 minutes.
With the engine idling, check the vacuum of the vacuum pump assembly.
More than 86.7 kPa (650 mmHg, 25.6 in.Hg)
If the pressure is less than the standard, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.
Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM PUMP (for 2GR-FKS)>INSPECTION
Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.
Remove the vacuum gauge from the vacuum pump assembly.
Connect the air tube to the vacuum pump assembly and slide the clip to secure it.
53607A
4.INSTALL FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY
55708
5.INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY