The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel filter removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
83320
2.REMOVE FUEL SENDER GAUGE ASSEMBLY
23221
3.REMOVE FUEL PUMP
23070
4.REMOVE FUEL MAIN VALVE ASSEMBLY (for Low Pressure)
23070
5.REMOVE FUEL MAIN VALVE ASSEMBLY (for High Pressure)
77174
6.REMOVE NO. 1 FUEL SUCTION SUPPORT
Remove the No. 1 fuel suction support from the fuel filter.
77174
7.INSTALL NO. 1 FUEL SUCTION SUPPORT
Install the No. 1 fuel suction support to the fuel filter.
23070
8.INSTALL FUEL MAIN VALVE ASSEMBLY (for High Pressure)
23070
9.INSTALL FUEL MAIN VALVE ASSEMBLY (for Low Pressure)
23221
10.INSTALL FUEL PUMP
83320
11.INSTALL FUEL SENDER GAUGE ASSEMBLY
77020A
12.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY