Home › Engine / Hybrid System › 2AR-FE (COOLING) › WATER PUMP › 2017.09–2018.04
RM33A0E _51 Engine / Hybrid System _065328 2AR-FE COOLING _0319474 WATER PUMP A

2AR-FE COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 27020 2.REMOVE GENERATOR ASSEMBLY

Hide 16620 3.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

Hide 16100 4.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A194904

Remove the 7 bolts, engine water pump assembly and water pump gasket.