Home › Engine / Hybrid System › 2AR-FE (COOLING) › THERMOSTAT › 2017.09–2018.04
RM33A0E _51 Engine / Hybrid System _065328 2AR-FE COOLING _0319475 THERMOSTAT A

2AR-FE COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the thermostat removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 27020 2.REMOVE GENERATOR ASSEMBLY

Hide 16572D 3.DISCONNECT NO. 2 RADIATOR HOSE

Hide 16321 4.REMOVE WATER INLET

a.
A406821

Remove the 2 nuts and water inlet.


Hide 16331A 5.REMOVE THERMOSTAT

a.

Remove the thermostat from the water inlet housing.


b.

Remove the gasket from the thermostat.