Home › Vehicle Interior › METER / GAUGE / DISPLAY › CLOCK SYSTEM › 2017.09–2018.04
RM33A0E _58 Vehicle Interior _065381 METER / GAUGE / DISPLAY _0323397 CLOCK SYSTEM T

METER / GAUGE / DISPLAY  CLOCK SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type)>PRECAUTION

·

The following may occur if a radio and display receiver assembly from another vehicle is installed to this vehicle. Therefore, when replacing the radio and display receiver assembly, be sure to replace it with a new one.

-

A communication malfunction DTC is stored.

-

The radio and display receiver assembly does not operate normally.




HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Clock System (w/ No. 1 Stereo Jack Adapter Assembly)
Symptom Suspected Area Link
Clock display is not displayed Fuse (ECU-IG1 NO. 4, ECU-ACC, TV) -
Wire harness or connector -
Radio and display receiver assembly Click here
Clock loses or gains time Check customize parameters Click here
Navigation system*1 Click here
Audio and visual system*2 Click here
Radio and display receiver assembly Click here
Clock cannot be adjusted Check customize parameters Click here
Navigation system*1 Click here
Audio and visual system*2 Click here
Radio and display receiver assembly Click here
Clock is not automatically adjusted to time from GPS signals Navigation system*1 Click here
Audio and visual system*2 Click here
Navigation antenna assembly Click here
Antenna cord sub-assembly Click here
Radio and display receiver assembly Click here

*1: w/ Navigation System

*2: w/o Navigation System


Clock System (w/o No. 1 Stereo Jack Adapter Assembly)
Symptom Suspected Area Link
Clock display is not displayed Fuse (ECU-ACC, ECU-DCC NO. 2) -
Wire harness or connector -
Clock assembly Click here
Clock does not dim (when taillights are on) Wire harness or connector -
Main body ECU (Multiplex network body ECU) Click here
Clock assembly Click here
Clock loses or gains time Clock assembly Click here
Clock cannot be adjusted Clock assembly Click here