Home › Drivetrain › UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › TRANSMISSION CONTROL CABLE
RM33A0E _52 Drivetrain _065352 UB80E AUTOMATIC TRANSMISSION / TRANSAXLE _0326591 TRANSMISSION CONTROL CABLE A

UB80E AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  INSTALLATION  


PROCEDURE

Hide 33820B 1.INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the vehicle body with the 2 nuts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


b.

Connect the transmission control cable assembly to the vehicle body with the 2 nuts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)


c.

Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.


d.
C378147C01
0.729,2.063 1.031,2.292 0.302,0.229 10 false *a 2.094,2.063 2.375,2.313 0.281,0.25 10 false *b
*a Correct
*b Incorrect


Connect the transmission control cable assembly to the transmission control shaft lever as shown in the illustration.

NOTICE:

Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.



Hide 58861B 2.INSTALL NO. 1 CONSOLE BOX DUCT

a.

Install the No. 1 console box duct.


Hide 3.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

Hide 58152A 4.INSTALL FRONT LOWER NO. 1 FLOOR HEAT INSULATOR

a.

Install the front lower No. 1 floor heat insulator to the vehicle body with the 2 nuts.

Torque:
4.9 N*m (50 kgf*cm, 43 in.*lbf)


Hide 17410 5.INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

Hide 74404A 6.INSTALL BATTERY CLAMP SUB-ASSEMBLY

Hide 28800 8.INSTALL BATTERY