Home › Engine / Hybrid System › 2GR-FKS (COOLING) › THERMOSTAT
RM33A0E _51 Engine / Hybrid System _065337 2GR-FKS COOLING _0326739 THERMOSTAT A

2GR-FKS COOLING  THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 16031 1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.

Install a new gasket to the water inlet with thermostat sub-assembly.


b.

Install the water inlet with thermostat sub-assembly with the 2 bolts and 2 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 16261 2.CONNECT WATER BY-PASS HOSE

a.

Connect the water by-pass hose and slide the clip to secure it.


Hide 12315 3.INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH

Hide 82121 4.CONNECT ENGINE WIRE

a.

Engage the clamp to connect the engine wire.


b.

Install the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the water inlet with thermostat sub-assembly connector.


Hide 12305 5.INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

a.
A504155N01
1.083,1.875 1.26,2.094 0.177,0.219 10 true A 2.052,0.271 2.229,0.49 0.177,0.219 10 true B 0.948,0.073 1.125,0.292 0.177,0.219 10 true C

Install the engine mounting insulator sub-assembly RH to the engine mounting spacer and vehicle body with the nut and 2 bolts.

Torque:
72 N*m (734 kgf*cm, 53 ft.*lbf)

NOTICE:

Temporarily tighten the bolt (A), and then fully tighten the 2 bolts and nut in the order of (B), (A) and (C).



b.

Install the engine mounting insulator sub-assembly RH to the front No. 1 engine mounting bracket LH with the 3 bolts and nut.

Torque:
Bolt : 72 N*m (734 kgf*cm, 53 ft.*lbf)
Nut : 42 N*m (428 kgf*cm, 31 ft.*lbf)


c.

Connect the No. 1 bond cable to the engine mounting insulator sub-assembly RH with the bolt.

Torque:
9.5 N*m (97 kgf*cm, 84 in.*lbf)


d.

Install the suction hose sub-assembly, suction pipe sub-assembly and air conditioning tube and accessory assembly with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Engage the 2 clamps.


Hide 16470 6.INSTALL RADIATOR RESERVE TANK ASSEMBLY

a.
A504150N01
1.042,1.823 1.219,2.063 0.177,0.24 10 true 1 1.427,0.115 1.583,0.313 0.156,0.198 10 true 2

Install the radiator reserve tank assembly with the bolt and nut in the order shown in the illustration.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


b.

Engage the clamp.


Hide 12327A 7.INSTALL NO. 2 ENGINE MOUNTING STAY RH

Hide 11209 8.INSTALL V-BANK COVER SUB-ASSEMBLY

Hide 9.ADD ENGINE COOLANT