Home › Engine / Hybrid System › 2GR-FKS (COOLING) › THERMOSTAT › 2017.09–2018.04
RM33A0E _51 Engine / Hybrid System _065337 2GR-FKS COOLING _0326739 THERMOSTAT A

2GR-FKS COOLING  THERMOSTAT  REMOVAL  


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 11209 2.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 12327A 3.REMOVE NO. 2 ENGINE MOUNTING STAY RH

Hide 16470 4.SEPARATE RADIATOR RESERVE TANK ASSEMBLY

a.
A504150

Disengage the clamp.


b.

Remove the bolt, nut to separate the radiator reserve tank assembly.


Hide 12305 5.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH

a.
A504151

Disengage the 2 clamps.


b.

Remove the bolt to separate the suction hose sub-assembly, suction pipe sub-assembly and air conditioning tube and accessory assembly.


c.
A505085

Remove the bolt to disconnect the No. 1 bond cable from the engine mounting insulator sub-assembly RH.


d.

Using a safety stand, support the engine assembly with transaxle at the position shown in the illustration.

A504153C02
4.365,1.896 4.521,2.094 0.156,0.198 10 false -
V100155

Support Area - -


NOTICE:
·

Make sure to firmly support the weight of the engine assembly and automatic transaxle assembly before removing the engine mounting insulator sub-assembly RH.

·

Do not place the safety stand under the oil pan.




e.
A508907C01
0,0 0,0 false
V100155

Support Area


Support the engine assembly with automatic transaxle assembly at the position shown in the illustration to stabilize it.


f.
A504154

Remove the 3 bolts and nut to separate the engine mounting insulator sub-assembly RH from the front No. 1 engine mounting bracket LH.


g.
A504155

Remove the nut, 2 bolts and engine mounting insulator sub-assembly RH from the engine mounting spacer and vehicle body.


Hide 82121 6.DISCONNECT ENGINE WIRE

a.
A407189

Disconnect the water inlet with thermostat sub-assembly connector.


b.

Remove the bolt.


c.

Disengage the clamp to disconnect the engine wire.


Hide 12315 7.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH

Hide 16261 8.DISCONNECT WATER BY-PASS HOSE

a.
A368523

Slide the clip and disconnect the water by-pass hose.


Hide 16031 9.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A368720

Remove the 2 bolts, 2 nuts and water inlet with thermostat sub-assembly.


b.

Remove the gasket from the water inlet with thermostat sub-assembly.