This DTC is stored when the skid control ECU (brake actuator assembly) receives a sensor supply voltage malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly).
The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1381 | Acceleration Sensor Power Supply Voltage Malfunction | Vehicle speed is 6 km/h (4 mph) or higher and yaw rate and acceleration sensor power supply malfunction signal is received for 1.1 seconds or more. | ·
Acceleration sensor power source circuit ·
Acceleration sensor (airbag sensor assembly) |
Refer to DTCs C1234, C1472 and C1474.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1234
Inspect the fuses for circuits related to this system before performing the following procedure.
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform system variant learning and acceleration sensor zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
| *a | Front view of wire harness connector
(to Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly)) |
Make sure that there is no looseness at the locking part and the connecting part of the connector.
The connector is securely connected.
Disconnect the K73 yaw rate and acceleration sensor (airbag sensor assembly) connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K73-36 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector (to Yaw Rate and Acceleration Sensor (Airbag Sensor Assembly)) |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K73-33 (E1) - Body ground | Always | Below 1 Ω |
| K73-32 (E2) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG