Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
73940A
1.INSTALL REAR SEAT AIRBAG ASSEMBLY
Install the rear seat airbag assembly with 2 new nuts.
Do not reuse the nuts.
Make sure that the rear side seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.
Connect the wire harness to the wire harness clamp.
Engage the clamp.
2.INSTALL REAR SIDE SEATBACK COVER WITH PAD
73344
3.INSTALL REAR SEAT SHOULDER BELT GUIDE
4.INSTALL REAR SIDE SEATBACK ASSEMBLY
62332A
5.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
72693
6.INSTALL REAR SEAT CUSHION LOCK HOOK
7.INSTALL REAR SEAT CUSHION ASSEMBLY
73350C
8.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
10. PERFORM DIAGNOSTIC SYSTEM CHECK
11.INSPECT SRS WARNING LIGHT