Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328126 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  TV Screen is Distorted  


CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION

·

When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly or navigation ECU may not operate normally.




PROCEDURE

1.CHECK OPTIONAL COMPONENTS
a.

Check if any optional components that may decrease reception capacity, such as a sunshade film or a telephone antenna, are installed.

Result:
Result Proceed to
Optional components are not installed A
Optional components are installed B


NOTICE:

Do not remove optional components without the permission of the customer.




A

2.CHECK WINDOW GLASS ANTENNA WIRE

B

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)

2.CHECK WINDOW GLASS ANTENNA WIRE
a.
E111994C14
0.432,0.608 0.62,0.765 0.188,0.156 10 *a 0.946,1.965 1.141,2.114 0.195,0.149 10 *b 2.178,1.735 2.366,1.885 0.188,0.149 10 *c 0.528,0.797 0.602,1.13 false 0.97,1.623 1.044,1.956 false 2.192,1.375 2.266,1.708 false
*a Tester Probe
*b Antenna Wire
*c Tin Foil


Check for continuity in the window glass antenna wire.

HINT:

Check for continuity at the center of each antenna wire as shown in the illustration.


NOTICE:

When cleaning the glass, wipe it in the direction of the wire with a soft dry cloth. Take care not to damage the wire. Do not use detergents or glass cleaners with abrasive ingredients. When measuring resistance, wrap a piece of tin foil around the tip of each probe and press the foil against the wire with your finger, as shown in the illustration.


OK:

There is continuity in the window glass antenna wire.



Result:
Proceed to
OK
NG



OK

3.CHECK DTV RECEPTION (OPERATION CHECK)

NG

3.CHECK DTV RECEPTION (OPERATION CHECK)
a.

Enter the "DTV reception check" screen. Refer to Check Digital Television Reception in Operation Check.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK

HINT:
·

As digital TV is a terrestrial broadcast, the digital TV antenna cannot receive the signal in places where the signal may not reach the vehicle, such as mountains or tunnels.

·

Even in areas where digital TV broadcasts for households can be received, the in-vehicle digital TV may not be able to receive the broadcast.




b.
E276609

Check the digital TV tuner reception level.

HINT:
·

Do not depend solely on the reception level as a reference value as it may vary depending on signal conditions such as wave interference.

·

If the result changes after turning the vehicle around, it is not due to a malfunction, but is caused by a local weak electric field.



OK:

Digital TV tuner reception level check result indicates good reception.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

4.REPLACE ANTENNA CORD SUB-ASSEMBLY (for Front Side)
4.REPLACE ANTENNA CORD SUB-ASSEMBLY (for Front Side)
a.

Replace the antenna cord sub-assembly (for front side) and check if digital television broadcasts can be received normally.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL

OK:

Digital television broadcasts can be received normally.



Result:
Proceed to
OK
NG



OK

END

NG

5.REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY
5.REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY
a.

Replace the No. 2 antenna cord sub-assembly and check if digital television broadcasts can be received normally.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO ANTENNA CORD>REMOVAL

OK:

Digital television broadcasts can be received normally.



Result:
Proceed to
OK
NG



OK

END

NG

6.REPLACE NO. 3 ANTENNA CORD SUB-ASSEMBLY
6.REPLACE NO. 3 ANTENNA CORD SUB-ASSEMBLY
a.

Replace the No. 3 antenna cord sub-assembly and check if digital television broadcasts can be received normally.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>ANTENNA CORD>REMOVAL

OK:

Digital television broadcasts can be received normally.



Result:
Proceed to
OK
NG



OK

END

NG

7.REPLACE TELEVISION ANTENNA ASSEMBLY
7.REPLACE TELEVISION ANTENNA ASSEMBLY
a.

Replace the television antenna assembly and check if digital television broadcasts can be received normally.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>TELEVISION ANTENNA>REMOVAL

OK:

Digital television broadcasts can be received normally.



Result:
Proceed to
OK
NG



OK

END

NG