Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2017.09–2018.04
RM33A0E _55 Steering _065370 POWER ASSIST SYSTEMS _0327166 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1582  Assist Map Number Mismatch  


DESCRIPTION

When an incorrect ECM, main body ECU (multiplex network body ECU) or skid control ECU (brake actuator assembly) is installed after the assist map has been written to the power steering ECU (rack and pinion power steering gear assembly), DTC C1582 is stored because the information stored in the power steering ECU (rack and pinion power steering gear assembly) does not match the vehicle specifications.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1582 Assist Map Number Mismatch Assist map number mismatch
·

CAN communication system

·

Incorrect ECM

·

Incorrect main body ECU (multiplex network body ECU)

·

Incorrect skid control ECU (brake actuator assembly)

·

Rack and pinion power steering gear assembly


EPS warning light: Does not come on Ignition switch is turned to ON again -

CAUTION / NOTICE / HINT

NOTICE:

If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


HINT:

Related parts store information necessary for assist map writing.

Related Part:

·

ECM

·

Main body ECU (Multiplex network body ECU)

·

Skid control ECU (Brake actuator assembly)



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM

Result:
Result Proceed to
CAN communication system DTCs are not output. A
CAN communication system DTCs are output. B



A

2.CHECK RELATED PART

B

2.CHECK RELATED PART
a.

Check if the part below has been replaced with an incorrect part in the past.

Related Part ECM
Main body ECU (Multiplex network body ECU)
Skid control ECU (Brake actuator assembly)

NOTICE:

When removing the related part to check it, be sure to follow the appropriate procedures and precautions.




b.

When DTC C1582 is output and parts have not been exchanged, replace the power steering ECU (rack and pinion power steering gear assembly) as it may have an internal malfunction.

NOTICE:

If the rack and pinion power steering gear assembly has been replaced, perform assist map writing.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION



Result:
Result Proceed to
The related part has an incorrect part number. A
The related part has the correct part number, or a related part and rack and pinion power steering gear assembly have not been replaced. B



A

3.REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER

B

REPLACE RACK AND PINION POWER STEERING GEAR ASSEMBLY

3.REPLACE RELATED PART WITH PART THAT HAS CORRECT PART NUMBER
a.

Replace the related part with one that has the correct part number.



Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Check for DTCs.

Chassis > EMPS > Trouble Codes
50001 142

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

END

B

REPLACE RACK AND PINION POWER STEERING GEAR ASSEMBLY