Home › Vehicle Interior › SEAT › SEAT HEATER SYSTEM
RM33A0E _58 Vehicle Interior _065385 SEAT _0328609 SEAT HEATER SYSTEM C

SEAT  SEAT HEATER SYSTEM  B14C1  Front Left Seat Heat Sensor Circuit  


DESCRIPTION

Output to the front seat cushion heater temperature sensor stops if one of the following occurs: 1) the temperature sensor is open or shorted; or 2) the temperature sensor is damaged and its output value does not change.

DTC No. Detection Item DTC Detection Condition Trouble Area
B14C1 Front Left Seat Heat Sensor Circuit Seat heater temperature sensor malfunction
·

Air conditioning amplifier assembly

·

Front Seat Cushion Heater Assembly LH

·

Wire harness or connector



WIRING DIAGRAM

B481385E05
2.177,0.917 2.635,1.115 0.458,0.198 10 false TSL 2.125,1.594 2.74,1.792 0.615,0.198 10 false SG-5 1.344,1.198 1.656,1.396 0.313,0.198 10 false 5 V 2.583,0.885 2.896,1.083 0.313,0.198 10 false 17 2.635,1.417 2.792,1.615 0.156,0.198 10 false 8 2.552,1.063 3.01,1.26 0.458,0.198 10 false K56 2.563,1.583 3.021,1.781 0.458,0.198 10 false K55 4.219,0.969 4.375,1.167 0.156,0.198 10 false 4 4.229,1.479 4.385,1.677 0.156,0.198 10 false 5 3.99,2.031 4.448,2.229 0.458,0.198 10 false b6 3.99,2.188 6.604,2.521 2.615,0.333 10 false Front Seat Cushion Heater Assembly LH 0.813,2.063 4.021,2.26 3.208,0.198 10 false Air Conditioning Amplifier Assembly

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Body Electrical > Air Conditioner > Clear DTCs
50002 121

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs.

Body Electrical > Air Conditioner > Trouble Codes
50001 121
OK:

DTC B14C1 is not output.



Result:
Proceed to
OK
NG



OK

NG

3.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
3.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
a.

Remove the front seat cushion heater assembly LH.

for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Manual Seat)>REMOVAL

for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>REMOVAL


b.

Inspect the front seat cushion heater assembly LH.

for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Manual Seat)>INSPECTION

for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT CUSHION HEATER(for Power Seat)>INSPECTION


Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - FRONT SEAT CUSHION HEATER ASSEMBLY LH)

NG

REPLACE FRONT SEAT CUSHION HEATER ASSEMBLY LH

4.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - FRONT SEAT CUSHION HEATER ASSEMBLY LH)
a.

Disconnect the b6 front seat cushion heater assembly LH connector.


b.

Disconnect the K55 and K56 air conditioning amplifier assembly connectors.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K56-17 (TSL) - b6-4 Always Below 1 Ω
K56-17 (TSL) or b6-4 - Body ground Always 10 kΩ or higher
K55-8 (SG-5) - b6-5 Always Below 1 Ω
K55-8 (SG-5) or b6-5 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR