Home › Engine / Hybrid System › 2GR-FKS (LUBRICATION) › OIL PRESSURE SWITCH
RM33A0E _51 Engine / Hybrid System _065338 2GR-FKS LUBRICATION _0328791 OIL PRESSURE SWITCH A

2GR-FKS LUBRICATION  OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 83530 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.
A304094C07
1.469,0.354 1.927,0.698 true 1.802,1.25 2.063,1.438 2.063,1.438 2.292,1.438 true 1.25,0.24 1.563,0.396 0.313,0.156 10 false *a 2.323,1.323 2.635,1.521 0.313,0.198 10 false *b
*a Adhesive 1344
*b Oil Inlet Port


Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
·

Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

·

Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.




b.

Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine for at least 1 hour after installation.



c.

Connect the engine oil pressure switch assembly connector.


d.

Engage the clamp to connect the wire harness protector.


Hide 53736 5.INSTALL FRONT FENDER APRON SEAL RH