15710
1.INSTALL OIL COOLER ASSEMBLY
Clean the installation surfaces of the oil cooler assembly.
Apply a small amount of engine oil to 3 new gaskets.
Install the 3 gaskets to the oil cooler assembly.
Temporarily install the oil cooler assembly to the water inlet housing with the oil cooler union bolt, nut and a new seal washer.
| *1 | Oil Cooler Union Bolt |
| *2 | Seal Washer |
Using several steps, uniformly install and tighten the oil cooler union bolt and nut in the order shown in the illustration.
25051
2.INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY (TWC: Front Catalyst)
11452
3.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
4.ADD ENGINE COOLANT
5.ADD ENGINE OIL
6.INSPECT FOR COOLANT LEAK
7.CHECK ENGINE OIL LEVEL
8.INSPECT FOR OIL LEAK