29300
1.INSTALL VACUUM PUMP ASSEMBLY
When installing a new vacuum pump assembly:
| *1 | O-ring (A) |
| *2 | O-ring (B) |
|
Engine Oil |
Apply engine oil to the O-ring (A).
Do not apply engine oil to the O-ring (B).
When reusing the vacuum pump assembly:
| *1 | O-ring (A) |
| *2 | O-ring (B) |
|
Engine Oil |
Install a new O-ring (B) to the vacuum pump assembly.
Apply engine oil to a new O-ring (A) and install it to the vacuum pump assembly.
Do not apply engine oil to the O-ring (B).
| *a | Coupling Teeth |
| *b | Groove |
| *c | Oil Pipe |
Temporarily install the vacuum pump assembly so that the oil pipe engages with the hole of the camshaft and the coupling teeth engage with the groove of the camshaft.
Ensure that the vacuum pump assembly is installed securely.
Be careful not to pinch the O-ring.
Install the vacuum pump assembly with the 4 bolts.
After installation, check that there are no gaps between the matching surfaces and that the vacuum pump assembly is not installed at an angle.
44773F
2.CONNECT UNION TO CHECK VALVE HOSE
Connect the union to check valve hose to the vacuum pump assembly and slide the clip to secure it.
3.INSTALL WIRING HARNESS CLAMP BRACKET
Install the wiring harness clamp bracket with the bolt.
4.INSTALL EGR VALVE WITH COOLER ASSEMBLY
5.INSPECT VACUUM PUMP OPERATION