The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake booster assembly removal/installation are shown below.
Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
55606
3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55708
4.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
53607A
5.REMOVE FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY
12601B
6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (for 6AR-FSE)
7.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE (for 6AR-FSE)
8.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE (for 2AR-FE)
12601B
9.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (for A25A-FKS)
10.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE (for A25A-FKS)
11.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE (for 2GR-FKS)
74404A
12.REMOVE BATTERY CLAMP SUB-ASSEMBLY
for A25A-FKS:
Disengage the 4 clamps from the battery clamp sub-assembly.
Remove the 3 bolts, nut and battery clamp sub-assembly.
for 6AR-FSE, 2AR-FE, 2GR-FKS:
Disengage the 5 clamps from the battery clamp sub-assembly.
Remove the 3 bolts, nut and battery clamp sub-assembly.
44773F
13.DISCONNECT UNION TO CHECK VALVE HOSE (for 6AR-FSE, A25A-FKS, 2GR-FKS)
Slide the clip and disconnect the union to check valve hose from the brake booster assembly.
44763A
14.SEPARATE NO. 1 HOSE TO HOSE TUBE (for 2AR-FE)
Slide the clip and disconnect the check valve to connector tube hose from the brake booster assembly.
Remove the 2 nuts and separate the No. 1 hose to hose tube from the vehicle body.
15.LOOSEN LOCK NUT
| *1 | Lock Nut |
| *2 | Brake Master Cylinder Push Rod Clevis |
Loosen the lock nut of the brake master cylinder push rod clevis.
47264A
16.REMOVE PUSH ROD PIN
44610
17.REMOVE BRAKE BOOSTER ASSEMBLY
for 6AR-FSE, A25A-FKS, 2GR-FKS:
Disconnect the connector from the vacuum warning switch assembly.
Remove the 4 nuts and push the brake booster assembly toward the engine compartment.
Do not apply excessive force to the brake lines.
Remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.
Remove the brake booster assembly from the vehicle body.
Do not apply excessive force to the brake lines.
44785
18.REMOVE BRAKE BOOSTER GASKET