1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
16361A
2.REMOVE V-RIBBED BELT
53295E
3.REMOVE COOL AIR INTAKE DUCT SEAL
17750A
4.REMOVE INLET AIR CLEANER ASSEMBLY
88711
5.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose sub-assembly from the compressor assembly with magnetic clutch.
Remove the O-ring from the No. 1 cooler refrigerant discharge hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88704
6.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the suction hose sub-assembly from the compressor assembly with magnetic clutch.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88310E
7.REMOVE COMPRESSOR ASSEMBLY WITH MAGNETIC CLUTCH
Disengage each clamp.
Disconnect each connector.
for Type A:
| *a | Bracket |
|
Bolt |
|
Nut |
Remove the 2 bolts and 2 nuts, and separate the bracket.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts.
for Type B:
| *a | Bracket |
Remove the 4 bolts and separate the bracket.
Remove the compressor assembly with magnetic clutch.