Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _072211 TELEMATICS _0351443 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B1583  GPS Signal Unreceived  


DESCRIPTION

This DTC is stored when GNSS satellite signals are not received for 30 km.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1583 GPS Signal Unreceived GNSS signals are not received for 30 km
·

Telematics transceiver

·

Roof antenna assembly

·

Antenna divider*

·

Antenna cord sub-assembly (for Type A)

·

Antenna cord sub-assembly (for Type B)*

·

No. 2 antenna cord sub-assembly

·

No. 5 antenna sub-cord assembly



*: w/ Antenna Divider


CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION


PROCEDURE

1.MOVE VEHICLE
a.

If the vehicle is outside the communication service area, move the vehicle into a communication service area, wait for a while and perform the operation again.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

b.

Drive the vehicle for 30 km or more.


c.

Turn the engine switch off.


d.

Connect the GTS to the DLC3.


e.

Turn the engine switch on (IG) and wait for 10 seconds or more.


f.

Turn the GTS on.


g.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

3.CHECK MODEL
3.CHECK MODEL
a.

Choose the model to be inspected.

Result:
Result Proceed to
w/o Antenna Divider A
w/ Antenna Divider B




A

4.CHECK OPTIONAL COMPONENTS

B

11.CHECK OPTIONAL COMPONENTS
4.CHECK OPTIONAL COMPONENTS
a.

Check if any optional components that may decrease reception capacity, such as a sunshade film or telephone antenna, are installed.

Result:
Result Proceed to
Optional components are not installed A
Optional components are installed B


NOTICE:

Do not remove optional components without the permission of the customer.




A

5.CHECK DTC OUTPUT

B

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)

5.CHECK DTC OUTPUT
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
No DTCs are output. A
DTC B1583 is output. B



A

END

B

6.INSPECT NO. 5 ANTENNA CORD SUB-ASSEMBLY
6.INSPECT NO. 5 ANTENNA CORD SUB-ASSEMBLY

OK

7.INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY

NG

REPLACE NO. 5 ANTENNA CORD SUB-ASSEMBLY

7.INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY

OK

8.INSPECT ANTENNA CORD SUB-ASSEMBLY (for Type A)

NG

REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY

8.INSPECT ANTENNA CORD SUB-ASSEMBLY (for Type A)

OK

9.REPLACE ROOF ANTENNA ASSEMBLY

NG

REPLACE ANTENNA CORD SUB-ASSEMBLY (for Type A)

9.REPLACE ROOF ANTENNA ASSEMBLY
a.

Replace the roof antenna assembly with a new or known good one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEPHONE ANTENNA>REMOVAL


b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

10.REPLACE TELEMATICS TRANSCEIVER
10.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT

11.CHECK OPTIONAL COMPONENTS
a.

Check if any optional components that may decrease reception capacity, such as a sunshade film or telephone antenna, are installed.

Result:
Result Proceed to
Optional components are not installed A
Optional components are installed B


NOTICE:

Do not remove optional components without the permission of the customer.




A

12.CHECK DTC OUTPUT

B

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)

12.CHECK DTC OUTPUT
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
No DTCs are output. A
DTC B1583 is output. B



A

END

B

13.INSPECT NO. 5 ANTENNA CORD SUB-ASSEMBLY
13.INSPECT NO. 5 ANTENNA CORD SUB-ASSEMBLY

OK

14.INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY

NG

REPLACE NO. 5 ANTENNA CORD SUB-ASSEMBLY

14.INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY

OK

15.INSPECT ANTENNA CORD SUB-ASSEMBLY (for Type A)

NG

REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY

15.INSPECT ANTENNA CORD SUB-ASSEMBLY (for Type A)

OK

16.INSPECT ANTENNA CORD SUB-ASSEMBLY (for Type B)

NG

REPLACE ANTENNA CORD SUB-ASSEMBLY (for Type A)

16.INSPECT ANTENNA CORD SUB-ASSEMBLY (for Type B)

OK

17.INSPECT ANTENNA DIVIDER

NG

REPLACE ANTENNA CORD SUB-ASSEMBLY (for Type B)

17.INSPECT ANTENNA DIVIDER

OK

18.REPLACE ROOF ANTENNA ASSEMBLY

NG

18.REPLACE ROOF ANTENNA ASSEMBLY
a.

Replace the roof antenna assembly with a new or known good one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEPHONE ANTENNA>REMOVAL


b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

19.REPLACE TELEMATICS TRANSCEIVER
19.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT