This DTC is stored when the television camera controller detects a signal indicating a malfunction in the rear television camera assembly via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C2A63 | Back Camera Internal Circuit | A signal indicating a malfunction in the rear television camera assembly is detected. | Rear television camera assembly | Circumference Monitoring Camera Control Module |
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Clear the DTCs.
Check for DTCs.
DTC C2A63 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG