Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0351447 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C2A6A  Back Camera Response Malfunction  


DESCRIPTION

During self diagnosis of the television camera controller, the television camera controller sends display mode ID signals to the rear television camera assembly. This DTC is stored when the output of the rear television camera assembly does not match the expected output.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C2A6A Back Camera Response Malfunction Abnormal response from the rear television camera assembly
·

Rear television camera assembly

·

Television camera controller


Circumference Monitoring Camera Control Module

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Chassis > Panoramic View Monitor > Clear DTCs
50002 353

b.

Check for DTCs.

Chassis > Panoramic View Monitor > Trouble Codes
50001 353
OK:

DTC C2A6A is not output.



Result:
Proceed to
OK
NG



OK

NG

2.REPLACE REAR TELEVISION CAMERA ASSEMBLY
2.REPLACE REAR TELEVISION CAMERA ASSEMBLY
a.

Replace the rear television camera assembly with a new or normally functioning one.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA (for Rear)>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Clear the DTCs.

Chassis > Panoramic View Monitor > Clear DTCs
50002 353

b.

Check for DTCs.

Chassis > Panoramic View Monitor > Trouble Codes
50001 353
OK:

DTC C2A6A is not output.



Result:
Proceed to
OK
NG



OK

END (REAR TELEVISION CAMERA ASSEMBLY IS DEFECTIVE)

NG