Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0351447 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C2A5C  BSM Buzzer Sound Request Signal Malfunction  


DESCRIPTION

This DTC is stored when the rear television camera assembly receives an invalid communication signal from the blind spot monitor sensor RH.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C2A5C BSM Buzzer Sound Request Signal Malfunction An invalid communication signal is received from the blind spot monitor sensor RH Rear television camera assembly Rear Camera

CAUTION / NOTICE / HINT

NOTICE:
·

When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Chassis > Parking Assist Camera > Clear DTCs
50002 85

b.

Recheck for DTCs and check that no DTCs are output.

Chassis > Parking Assist Camera > Trouble Codes
50001 85

Result:
Result Proceed to
DTC C2A5C is output A
DTC C2A5C is not output B



A

B

END