This DTC is stored when the rear television camera assembly receives an RCTA buzzer circuit malfunction signal from the blind spot monitor sensor RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C2A5D | BSM Buzzer Malfunction | The RCTA buzzer circuit is abnormal. | Blind spot monitor system | Rear Camera |
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Blind Spot Monitor Slave / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Buzzer Connection | Status of the buzzer connection | Valid or Invalid | Valid: Buzzer connection is valid
Invalid: Buzzer connection is invalid |
- |
| Slave Side RCTA Function | Switches the RCTA function on and off | OFF or ON | OFF: RCTA function off
ON: RCTA function on |
- |
| Tester Display |
|---|
| Buzzer Connection |
| Slave Side RCTA Function |
| Result | Proceed to |
|---|---|
| "Valid" and "ON" is displayed for all items. | A |
| "Invalid" or "OFF" is displayed. | B |
A
B
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
| Result | Proceed to |
|---|---|
| DTC C2A5D is output | A |
| DTC C2A5D is not output | B |
A
B
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC C1ABE is output | A |
| DTC C1ABE is not output | B |
A
B