11301C
1.INSTALL TIMING CHAIN COVER OIL SEAL
w/o Side Lip:
Apply MP grease to the lip of a new timing gear case or timing chain case oil seal.
Keep the lip free from foreign matter.
Do not allow MP grease to contact the dust seal.
| *a | -0.75 to -1.45 mm (-0.0295 to -0.0571 in.) |
| *b | Dust Seal |
| *c | Lip |
Using SST and a plastic-faced hammer, tap in the timing gear case or timing chain case oil seal.
-0.75 to -1.45 mm (-0.0295 to -0.0571 in.) (From the edge of the timing chain cover sub-assembly)
Do not tap in the timing gear case or timing chain case oil seal at an angle.
Wipe off any MP grease from the crankshaft.
w/ Side Lip:
Apply MP grease to the lip of a new timing gear case or timing chain case oil seal.
Keep the lip free from foreign matter.
Do not allow MP grease to contact the dust seal.
Do not allow MP grease to contact the side lip.
| *a | Side Lip |
| *b | Correct |
| *c | Incorrect |
Fit the timing gear case or timing chain case oil seal to SST.
Visually check that the side lip is not caught on SST.
| *a | -0.75 to -1.45 mm (-0.0295 to -0.0571 in.) |
| *b | Side Lip |
| *c | Dust Seal |
| *d | Lip |
Using SST and a plastic-faced hammer, tap in the timing gear case or timing chain case oil seal.
-0.75 to -1.45 mm (-0.0295 to -0.0571 in.) (From the edge of the timing chain cover sub-assembly)
Do not tap in the timing gear case or timing chain case oil seal at an angle.
Wipe off any MP grease from the crankshaft.
13471
2.INSTALL CRANKSHAFT PULLEY
Align the crankshaft timing gear key with the key groove of the crankshaft pulley.
| *a | Hold |
| *b | Turn |
Using SST, hold the crankshaft pulley and install the crankshaft pulley bolt.
Insert a few washers (total thickness: approximately 5.0 mm (0.197 in.)) between SST (09213-70011) and SST (09214-00030).
16361A
3.INSTALL V-RIBBED BELT
4.INSTALL ENGINE ASSEMBLY WITH TRANSAXLE