13523F
1.INSPECT CAMSHAFT TIMING GEAR BOLT
Remove the camshaft timing oil control solenoid assembly.
Click hereEngine / Hybrid System>6AR-FSE (ENGINE CONTROL)>CAMSHAFT OIL CONTROL SOLENOID>REMOVAL
Check the stroke of the plunger in the center of the camshaft timing gear bolt.
4.5 mm (0.177 in.) or more
When pressing the plunger, there may be a stepped feeling. This is not a malfunction.
If the result is not as specified, replace the camshaft timing gear bolt.
Install the camshaft timing oil control solenoid assembly.
Click hereEngine / Hybrid System>6AR-FSE (ENGINE CONTROL)>CAMSHAFT OIL CONTROL SOLENOID>INSTALLATION