Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351519 ENGINE COOLANT TEMPERATURE SENSOR A

6AR-FSE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>6AR-FSE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Install a new gasket to the engine coolant temperature sensor.


b.
A413351N01
1.729,0.948 1.99,0.688 1.99,0.688 2.219,0.688 true 2.229,0.594 2.688,0.792 0.458,0.198 10 true SST

Using SST, install the engine coolant temperature sensor to the cylinder head sub-assembly.

SST
09817-33191  

Torque:
19.6 N*m (200 kgf*cm, 14 ft.*lbf)

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.



c.

Connect the engine coolant temperature sensor connector.


Hide 17705 2.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 4.ADD ENGINE COOLANT

Hide 6.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>6AR-FSE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION