Home › Engine / Hybrid System › 6AR-FSE (LUBRICATION) › ENGINE OIL COOLER › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072208 6AR-FSE LUBRICATION _0351653 ENGINE OIL COOLER A

6AR-FSE LUBRICATION  ENGINE OIL COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during oil cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
·

Replacement of air fuel ratio sensor

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 11452 3.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 15710 5.REMOVE OIL COOLER ASSEMBLY

a.
A409495C02
0.792,1.844 1,1.844 1,1.844 1.354,1.292 true 1.573,1.083 1.813,0.667 1.813,0.667 1.99,0.667 true 2.01,0.583 2.208,0.76 0.198,0.177 10 true *1 0.604,1.75 0.792,1.927 0.188,0.177 10 true *2
*1 Oil Cooler Union Bolt
*2 Seal Washer


Remove the oil cooler union bolt and seal washer.


b.

Remove the nut and oil cooler assembly from the water inlet housing.


c.

Remove the 3 gaskets from the oil cooler assembly.