Home › Engine / Hybrid System › 6AR-FSE (LUBRICATION) › ENGINE OIL COOLER › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072208 6AR-FSE LUBRICATION _0351653 ENGINE OIL COOLER A

6AR-FSE LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Clean the installation surfaces of the oil cooler assembly.


b.

Apply a small amount of engine oil to 3 new gaskets.


c.

Install the 3 gaskets to the oil cooler assembly.


d.

Temporarily install the oil cooler assembly to the water inlet housing with the oil cooler union bolt, nut and a new seal washer.


e.
A409495C01
0.792,1.844 1,1.844 1,1.844 1.354,1.292 true 1.573,1.083 1.813,0.667 1.813,0.667 1.99,0.667 true 2.01,0.583 2.208,0.76 0.198,0.177 10 true *1 0.604,1.75 0.792,1.927 0.188,0.177 10 true *2 2,1.115 2.156,1.313 0.156,0.198 10 true 1 0.74,0.458 0.896,0.656 0.156,0.198 10 true 2
*1 Oil Cooler Union Bolt
*2 Seal Washer


Using several steps, uniformly install and tighten the oil cooler union bolt and nut in the order shown in the illustration.

Torque:
Oil Cooler Union Bolt : 60 N*m (612 kgf*cm, 44 ft.*lbf)
Nut : 10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 11452 3.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

Hide 4.ADD ENGINE COOLANT

Hide 6.INSPECT FOR COOLANT LEAK