Home › Engine / Hybrid System › 6AR-FSE (EMISSION CONTROL) › EMISSION CONTROL SYSTEM › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072205 6AR-FSE EMISSION CONTROL _0353745 EMISSION CONTROL SYSTEM G

6AR-FSE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL CUT OPERATION

a.

Start the engine.


b.

Warm up the engine.


c.

Increase the engine speed to approximately 3500 rpm.


d.
A339006C01
1.719,1.188 1.365,1.906 1.365,1.906 1.188,1.906 true 2.146,0.969 2.385,1.479 2.385,1.479 2.552,1.479 true 0.99,1.833 1.219,2.094 0.229,0.26 10 false *1 2.604,1.375 2.833,1.615 0.229,0.24 10 true *a
*1 Fuel Injector Assembly
*a Sound Scope


Use a sound scope to check for fuel injector assembly operating sounds.


e.

When the accelerator pedal is fully released, check that fuel injector assembly operating sounds stop momentarily and then resume.

Standard:
Item Specified Condition
Fuel injection restart engine speed 1400 rpm


If the result is not as specified, check the fuel injector assemblies, wire harness and ECM.


Hide 2.VISUALLY CHECK HOSES, CONNECTIONS AND GASKETS

a.

Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

NOTICE:
·

Detachment or other problems with the engine oil level dipstick, oil filler cap sub-assembly, ventilation hose or other components may cause the engine to run improperly.

·

Air suction caused by disconnections, looseness or cracks in any part of the air induction system between the throttle body with motor assembly and cylinder head sub-assembly will cause engine failure or engine malfunctions.



If any defects are found, replace parts as necessary.


Hide 3.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

a.

Connect the GTS to the DLC3.


b.

Start the engine.


c.

Turn the GTS on.


d.
A412422

Slide the clip and disconnect the fuel vapor feed hose assembly from the purge valve (purge VSV).


e.

Enter the following menus: Powertrain / Engine / Active Test / Activate the EVAP Purge VSV.

Powertrain > Engine > Active Test
Tester Display
Activate the EVAP Purge VSV
50004 372 1

f.

Check that vacuum occurs at the purge valve (purge VSV) port.


g.

If vacuum does not occur, check the following items.

·

Purge valve (purge VSV)

·

Clogging in the fuel vapor hose that connects the intake manifold and purge valve (purge VSV)



h.

Exit Active Test mode and connect the fuel vapor feed hose assembly to the purge valve (purge VSV) and slide the clip to secure it.

Click hereEngine / Hybrid System>6AR-FSE (EMISSION CONTROL)>PURGE VALVE>INSTALLATION


i.

Enter the following menus: Powertrain / Engine / Data List / EVAP (Purge) VSV.

Powertrain > Engine > Data List
Tester Display
EVAP (Purge) VSV
50003 372 226

j.

Warm up the engine and drive the vehicle.


k.

Confirm that the purge valve (purge VSV) opens.

If the result is not as specified, replace the purge valve (purge VSV), wire harness or ECM.