Home › Engine / Hybrid System › 6AR-FSE (INTAKE / EXHAUST) › INTAKE MANIFOLD › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072206 6AR-FSE INTAKE / EXHAUST _0353755 INTAKE MANIFOLD A

6AR-FSE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body assembly

·

Cleaning the deposits from the throttle body assembly

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 55708 1.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

Hide 53607A 2.REMOVE FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY

Hide 22030 3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 12262 4.DISCONNECT NO. 2 VENTILATION HOSE

a.
A413908

Slide the clip and disconnect the No. 2 ventilation hose from the intake manifold.


Hide 89421 5.REMOVE VACUUM SENSOR (MANIFOLD ABSOLUTE PRESSURE SENSOR)

a.
A413931

Disconnect the vacuum sensor (manifold absolute pressure sensor) connector.


b.

Disconnect the vacuum hose from the intake manifold.


c.

Remove the bolt and vacuum sensor (manifold absolute pressure sensor) from the intake manifold.


Hide 25860 6.REMOVE PURGE VALVE (PURGE VSV)

a.
A413909C01
0.906,0.969 1.271,0.969 true 1.479,1.823 1.844,1.823 true 1.844,1.729 2.073,1.927 0.229,0.198 10 true *1 0.719,0.885 0.917,1.063 0.198,0.177 10 true *2
*1 Fuel Vapor Hose
*2 Fuel Vapor Feed Hose Assembly


Slide the clip and disconnect the fuel vapor hose from the intake manifold.


b.

Slide the clip and disconnect the fuel vapor feed hose assembly from the purge valve (purge VSV).


c.

Disconnect the purge valve (purge VSV) connector.


d.

Remove the bolt and purge valve (purge VSV) from the intake manifold.


Hide 25612 8.REMOVE NO. 2 EGR PIPE

a.
A413911

Disengage the wire harness clamp from the No. 2 EGR pipe.


b.
A413910

Remove the 4 bolts and No. 2 EGR pipe from the EGR valve assembly and intake manifold.


c.
A413912

Remove the No. 2 EGR pipe gasket from the EGR valve assembly.


d.
A413913

Remove the EGR inlet gasket from the intake manifold.


Hide 82121 9.DISCONNECT ENGINE WIRE

a.
A421926

Disconnect the 4 connectors.


b.
A421927

Disengage the 11 wire harness clamps and disconnect the engine wire.


Hide 17111 10.REMOVE INTAKE MANIFOLD

a.
A413916

Remove the 6 bolts and intake manifold from the cylinder head sub-assembly.


b.
A413917

Remove the manifold gasket from the intake manifold.